|
"David Baw gets high on the job — 160 feet high." "Towercrane operators at the SBC Center construction site rise to the challenge of working high above the ground." Pay particular attention to the following paragraphs when you read the article. (continue reading to link below) "Most operators use safety lines attached to the cranes to prevent a long fall, but Baw is considered a cowboy of sorts. Sometimes he traipses across the crane's jib without a safety line. But he sports an unblemished safety record in his more than 20 years on the job." Another statement copied from the story... "A few years ago, his high-wire routine got him tagged a "daredevil" in Charlotte, N.C., where he drew crowds of admirers standing in a nearby office building." Now go read the story about a "Cowboy of Sorts" a "Daredevil" * Footnote: Inaccurate information corrections
| ||
| | Dummy Awards Index | | HOME | | Back to CraneTalk Bulletin Board | |
* Footnote: "Steel beams stuck 75 feet deep into the group [apparently "group" is a typo - it should be ground] anchor the crane,..." Correction: About 6 or 7 feet into the ground is more likely to be the depth, not 75 feet. Apparently there were some misunderstandings between the writer of the article and the operators of the cranes about the above and several other technical details, i.e., wind speeds, sway, and bend numbers. One of the experts posted the following on our CraneTalk.com bulletin board. "Tower jib's don't bend 15'. Depending on the length, let's say 213' would deflect approximately 7'." |